Finally picked up a brush after a long haitus from the painting table. Nothing really kept me from it, but just wasn't in the mood for awhile. These are mostly Warlord Games figures with a couple of Old Glory mounted officers.
The Firelocks are leftovers from an Army Starter box, and were the last figures from that set. The two ensigns on the right are metal figures, and the two on the left the usual plastic ones that come with the foot sets. The mounted commander in the center is the Warlord Games Cromwell figure. The two mounted commanders on the far left and right are Old Glory figures. My buddy gave me a pack of Old Glory ECW mounted generals - and these two seemed the nicest out of the set of 10.The front row figures are Warlord Games, and the two in the rear are Old Glory.Left to right - OG, WG, WG, OG, WG. The mounted figures are a close match between the two makes. The WG horses are nicer, but the OG ones also match close enough. The center horse (with the Cromwell figure) is the largest - mainly due to it's longer legs.
Pictured below - I did a comparison with Minwax Tudor Satin stain and Army Painter Quickshade Dark Tone. Minwax was used on the blue firelocks, and Quickshades on the red guys. The ensign figures on the left of the blocks were stained with Minwax, and Quickshade was used the ensign figures on the right of the blocks. Quickshade was used on the two mounted figures on the left; and Minwax was used on the three mounted figures on the right. The application for both are the same - a brush was used to coat the figures - top to bottom, with a dab of mineral spirits every now and then to thin out the stain. It's not very noticeable, but the Minwax has a darker (blacker) shade that seems to settle into the recesses better, whereas the Quickshade has a brownish tone overall. I still prefer Minwax over Army Painter.Anyway, just a quick post to update the blog. Not sure when, but I hope to get a Pike & Shotte game in before the year is out. Thanks for stopping by, and wishing you all the best.





You picked up right where you left off with brilliant brushwork. I appreciate the stain comparison. I wonder if Minwax Expresso is close to Tudor?
ReplyDeleteThanks, Jonathan! I hadn't heard of Espresso before. I just Googled it, and saw that they're phasing out Tudor. I may have to try Espresso when my can of semi-dried Tudor is eventually gone. Warmest regards, Dean
DeleteSuperb ECW command and firelocks Dean! I use the acrylic AP soft tone wash for all my stuff, haven’t used the old AP tins for years.
ReplyDeleteThanks a lot, Mike. I rely heavily on stains/washes, and up until now Minwax Tudor Satin has been great. Now that it's being discontinued, I will have to find a good substitute. Warmest regards, Dean
DeleteWooow! Excellent work Dean!
ReplyDeleteThanks for your visit and kind words again, Michal! Warmest regards, Dean
DeleteI really don't see a lot of difference between the Miniwax and Army Painter stuff, Dean - but it may be more obvious in the flesh - either way, all these figures are up to your normal high standard!
ReplyDeleteThank you very much again, Keith. Honestly, the two results are quite similar. Either works well. Anyway, glad to have the figures completed. Kindest regards, Dean
DeleteFantastic work, Dean. Stick with what works. But sounds like you may need to buy in some stock to future proof.
ReplyDeleteThanks a lot, Richard. Worse case, I have the almost full can of Army Painter to use. Warmest regards, Dean
DeleteNice work Dean 👍
ReplyDeleteThank you very much, Matt. Kindest regards, Dean
DeleteGreat figurines, and as always, a magnificent finish! Congratulations on the useful addition!
ReplyDeleteThank you very much again, Alexey. Warmest regards, Dean
Delete